DECORATIVE CYLINDRICAL POLES

Our cylindrical poles are manufactured with tubular elements, made ​​from sheet 'steel S235 JRH (according to UNI EN 10219).
If buried line, at each pole are made to the following processes:
- Cable entry slot;
- Application of the plate grounded (or thread insert);
- Terminal board slot.

On top of the poles if required could 'be applied a shank
(H = 200 mm and diameter = 60 mm) suitable for mounting accessories and lighting.

The galvanizing is carried out by immersion of materials in tanks of molten zinc at a temperature of 450 ° C, where the thickness of the zinc coating and 'in accordance with the UNI EN ISO 1461.

In addition, our poles are manufactured in compliance with the UNI EN 40/5 and other related rules:
- Dimensions and tolerances: EN 40/2;
- Materials: EN 40/5;
- Specification for characteristic loads: EN 40/3/1;
- Verification by calculation: EN 40/3/3;
- Surface protection: EN 40/4;

Each pole also comes equipped with an adhesive label EC.

At the request of the customer can be made of steel poles with different characteristics:
- S275 JR (Fe430)
- S355 JR (Fe510B)

work poles up to 6 meters in height
or insert pocket-earth place to 600mm from pole base
132x38-loop cables placed at 350mm
132x38-door mail slot to 1500mm from bottom of the pole in the center hole

work poles taller than 6 m
pocket-grounding pole placed at 900mm from base
186x45-loop cables placed at 600mm from bottom of the pole in the center hole
186x45-door mail slot to 1800mm from bottom of the pole in the center hole

Optionals Special processing to the posts:

-Door cur flush with pole

-Square or circular base plate. Dimensions and thickness on request according to the type of application and type of pole
-Coupling with decorative reduction rings
-drip-ring or stop
-Reinforced door slot where necessary
-welded steel sleeve or shrink sleeve applied
-adjustable arm or flange
At the request of the customer the finish of the pole can 'be powder coated according to RAL international scale.